Image : http://www.flickr.com
If you need water heater repair to her and you forget where you manually set the warranty or help me, so you have some tips to guide you along. This guide assumes that the hot water heater has been installed and were working properly before any development problems. It 's more brands such as troubleshooting water heater Takagi, Rudd, Bosch, RV, or GE Rinnai water heater.
Common electric hot water heater problemsand repairs
Warning: electric water heater is a 240-volt device. The shock can produce can be fatal. Turn off the device to the service panel before starting work. Make sure the service panel with tape is that members of the family you are working in the current warning label.
Problem: Not enough hot water
Thermostat is set too low, it increases the temperature can be adjusted. Or is there sediment in the tank, drain it a try. The thermostat or heating element failedand must be replaced or the float may be damaged.
Problem: The hot water
Check the circuit breaker or fuse box. high temperature limit switch (ECO – Energy Cut Off) can be triggered. Determine if there is a problem and reset button. higher thermostat may have failed and requires replacement or heating element and can not be replaced.
Problem: Tank losses
Determine whether the loss of pipes and safety valves. Many water heaters use low-qualityValve that can be difficult to close securely. Use slip joint pliers to open the valve all the way closed. Caution: Excessive force may trigger the valve. If the valve has failed, a replacement is needed.
Problem: water heater is noisy
scale construction may occur over resistors causing all sorts of noise during heating. Remove the radiator and clean or replace it. The low water pressure may also be on site, or the tension of heating in boiling waterFactor.
Problem: Dirty water
Drain and rinse tank. This will regularly extend the life of your electric water heater. If the exhaust leaks, tighten or replace.
Common problems and repairs of gas water heaters:
Note: If you smell a smell of gas in the vicinity of gas detection value, the water supply for heating company immediately. Open the door or window to ventilate the room and call the gas.
Problem: Not enough hotWater
Thermostat is set too low, it increases the temperature can be adjusted. Or, if the sediment in the tank, drain it, test. Boiler is small, and had to be replaced with higher capacity model. Or it could be due to low gas pressure, so check with utility companies.
Problem: Water leaks
Operate the maximum pressure. Many water heaters use a low-quality valve that can be difficult to close tightly. Use slip joint pliers to open the valve all the way closed. Note:much force may trigger the valve. If the leak continues, and the temperature is OK, replace the value.
Problem: The light is not illuminated
Check that the thermocouple attached to the bolts of the thermostat. The thermocouple may have failed and must be replaced. It may be air or dirt in the gas line or pilot line or clean the opening, which can be blocked. inadequate combustion air to a gas burner to shut down for safety reasons.
Problem: Wateris too hot
Check and monitor the temperature. If too high, the thermostat must be professionally maintained.
Problem: Condensation on the tank
cold water in the tank can cause condensation outside. Ventilation may be inadequate. Substitution of a larger tank may help.
and knowledge to make and Abstract:
If you are still unsure about what to do, be sure to call the manufacturer for instructions or your local repair guy.