Image : http://www.flickr.com
Installing a water heater is a common repair work at home. It is not a complex process and homeowners can install to do it myself. It 'important to know that there is no room for error. And 'necessary, read the instructions and follow some simple guidelines to avoid undesirable results. The following are some steps to help you, heated water installed perfectly.
The first step in installing a new boiler is to remove the existing one.Before disconnecting the old drive, turn off the water, electricity or gas. If necessary, use a wrench, unscrew the inlet and outlet to remove hot water. For gas heaters, the answer to the vent pipe, that the hood is attached. Also remove the chimney cap at the top of the stove.
water heaters are heavy. It 'so use a fork to prevent damage while the unit is moved.
Enter your new drive in a sense, provides easy access for connectingPipes and controls. Ensure that gas water heaters connected firmly to prevent gas leaks. Keep a distance of 6 cm along the perimeter. Also, make sure that no flammable materials nearby.
Screw the inlet and outlet with blue and red in cold water in hot water outlet. Also, make sure the arrows on the pipes in the direction of the pour point of water. Next update in the third line the main water pipe.
Attach flexibleConnections to pipes entering and leaving. Install a valve on the cold water connection. Turn the pressure relief valve that controls the water heating and heat generated in the air.
After completing all connections, the last step is the connection to the new hot water, to power. Read the manual for correct wiring.
Open the tap water to fill the radiator. While it is filling, open the hot water into the air from water tapstubes.